Mustang Mach 1 Foglight holders

2024-05-08 09:42:47

本站旨在为打开T站有困难的用户，提供快速的检索服务，本站并不储存T站的模型资源，所以最终的模型下载要去到T站。

Summary

Created these to install a pair of fog lights into my 2022 Mustang Mach 1 grille.

The rings clip into the place where the grille inserts are (replace the inserts) on the Gen 6 Mach 1.

The clamps bolt through the top of the rings and the flat bit rests on top of the flat surface on the top of the grille aperture. Add VHB tape to this for extra strength.

Drill guide is to convert a single bolted fog light clamp to two bolt pattern. For the clamp you may need to remove some of the metal to not interfere with the top grille clip.

NOTE - This will need bumper removal to install

Lights used: -
https://www.amazon.co.uk/dp/B08SBLZLWK?ref=ppx_yo2ov_dt_b_product_details&th=1
(not affiliated)

Link to more details:-
https://www.mustang6g.com/forums/threads/mach-1-fog-light-install.201099/

Print Settings

Printer brand:
VoronDesign
Printer:
Voron2 350
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
80%
Filament brand:
AMZ3D
Filament color:
Black
Filament material:
ABS
Notes:
Used 80% infill with 1.6mm wall / top / bottom layer as wanted this very strong.

Post-Printing

Shaping

As there is a slight curve top to bottom of the grille apature you will need to put a slight top to bottom bend in the piece. Do this while the piece is still warm from printing (or heat up post print).